I get that, I plan to add another pihole ad some point so I can enter 2 nameservers at my router. There are solutions to sync all config between the piholes.

Semi monthly sounds like “monthly, or not” to me. Not sure about the alternatives I’ve seen so far

Cool, thanks!

I also planned to do the same (bare nginx instead of NPM but otherwise the same). Did you just remove the nginx container from docker compose and use the same arguments in NPM or do you double-reverseproxy or something else?

I mean every other week. I wasn’t aware of the other interpretation, but I think in combination with “The Sunday thread” it’s unambiguous?

I have never heard fortnightly, but then I’m not a native speaker. Is that commonly used?

I would run Debian from a stick and install Proxmox with the installer and not on top of Debian unless you have to. While the latter works, I found some settings around network interfaces to differ between the installation methods which caused me problems here and there.

Did you check Mint recently? If it’s been a while, it could also be dust buildup at the fan.

If you want to have domains assigned to local IP addresses, you can also use Pihole as a local DNS! It’s a very nice tool for adblocking on network level anyways, can only recommend it.

Cool! Which installation method did you use?

I hadn’t heard of Talos Linux, sounds cool! We are using haproxy as ingress controller with stepca for local certificates at work.

I didn’t know that, cool! Though I should probably talk to the mods before setting up such a thing.

Personally I’m mostly involved with my homelab migration so there’s not too much on the selfhosting page except os updates. I set up meshmini earlier to access my thin clients via vPro/AMT but I need to configure the clients before being able to actually using meshmini. Once I’m done with that I’ll finally be able to set up Lemmy and Pine pods.

My selfhosted stuff currently works fine without me doing much which feels good and lets me focus on hardware stuff currently.